Water Dryrun Guard (WDG-WC1)

LWDG-WC1

Motor Pump running in dry condition will burn the motor pump and thus it will stop after a very short time. Our product LIDER Water Dry Run Guard prevents the motor pump from dry running and thus subsequent burnout.

More details

Rs. 1,680

Product Description

PRODUCT DESCRIPTION/FEATURES
*Many a time, it happens that, water in the bore well/well aquifer discharge is less than motor pump discharge, and the water coming out of the motor pump is not continuous. *The motor pump which is submerged in water will give water till it is having sufficient water in bore-well. In case of insufficient water (when water level goes down), then the motor pump runs without giving water which is called dry running of motor pump. *Motor Pump running in dry condition will burn the motor pump and thus it will stop after a very short time. *Our product LIDER Water Level Guard prevents the motor pump from dry running and thus subsequent burnout. *When water in the bore-well falls below a set level (set by our sensing probe) often installed above the motor pump, a signalis sent initiating a trigger. *Thus LIDER Water Level Guard will switch OFF the motor pump AUTOMATICALLY as per set level position of sensing probe.

  • APPLICATION All Single Phase Motor Pumps without Contactor Control Panel including Monoblock/Openwell pumps etc. Our products are ideally suitable for water supply in houses, bungalows, offices, hospitals, factories, hotels & restaurants, apartments,multistory buildings, commercial centers and all places where Motor Pumps are installed in bore-well /wells. Please raise your query through email- liderelectricinfo@gmail.com or call at our helpline no 0761-2757173.
  • ADVANTAGES Small device, Saves Water, Electricity and Time. Auto and Manual switch provided for bypass condition. Easy to install in all kinds of deep borewells/wells. LED Indicator for water full (green) & water empty (red). NO maintenance required. Solid state PCB inside. Prevents the motor pump from burnout. Product directly going from Manufacturer to Consumer.

Product Features

ColourGREY
Dimensions (L X B X H)mm177mm*170mm*90mm
Weight (gms)1500
Voltage (volts)220~240 VAC, 50 Hz
Horsepower (HP)any HP rating pumps
Relay Output (amps)5 amps 240 VAC [R]
Connection DiagramConnection diagram provided with Nuts and Screws.
MountingWall mounting /Screw type.
MaterialPowder coated sheet metal
Quality ControlGovt. C.P.R.I. Bhopal Tested and Certified
Packing Box3 layer Corrugated
WarrantySix months against any manufacturing defect.

Product Reviews

Write a review

Water Dryrun Guard (WDG-WC1)

Water Dryrun Guard (WDG-WC1)

Motor Pump running in dry condition will burn the motor pump and thus it will stop after a very short time. Our product LIDER Water Dry Run Guard prevents the motor pump from dry running and thus subsequent burnout.

7 other products in the same category: